User's Manual

Chapter 12 Maintenance
WAP3205 User’s Guide
106
The following table describes the labels in this screen.
12.4 Password Screen
It is strongly recommended that you change your WAP3205's password.
If you forget your WAP3205's password (or IP address), you will need to reset the device. See
Section 12.8 on page 111 for details
Click Maintenance > Password.
Figure 76 Maintenance > Password
The following table describes the labels in this screen.
Table 43 Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the
session times out. The default is 5 minutes. After it times out you have to log in
with your password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter how long
it has been left idle (not recommended).
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to begin configuring this screen afresh.
Table 44 Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your WAP3205’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the
system in this field.
New Password Type your new system password (up to 30 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to begin configuring this screen afresh.