User's Manual

Chapter 5 Universal Repeater Mode
WAP3205 User’s Guide
39
5.6 Universal Repeater Screen
Use this screen to enter the SSID and select the wireless security mode used by the wireless device
to which you want to connect. Go to Configuration > Wireless LAN > Universal Repeater to
open the Universal Repeater screen. The screen varies depending on security mode.
Note: To have wireless clients access or acquire an IP address from another access point
or wireless router (B) through the WAP3205 (A) in universal repeater mode, you
must set the channel number in the Wireless LAN > General screen to be the
same as the one on the wireless router or AP to which the WAP3205 wants to
connect.
5.6.1 No Security
Figure 22 Universal Repeater Mode: Wireless LAN > Universal Repeater: No Security
The following table describes the labels in this screen.
A
B
Table 15 Universal Repeater Mode: Wireless LAN > Universal Repeater: No Security
LABEL DESCRIPTION
Universal Repeater Parameters
Enable Select this option to have the WAP3205 connect to the specified access point.
SSID Enter the name of the access point to which you are connecting.
MAC Address
(Optional)
Enter the MAC address of the access point to which you are connecting.
Security Mode Select No Security if the access point to which you want to connect does not use
encryption.
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to reload the previous configuration for this screen.