User's Manual

Chapter 17 Bandwidth Management
NBG-460N User’s Guide
241
The following table describes the labels in this screen.
17.5.2 Rule Configuration: User Defined Service Rule
Configuration
If you want to edit a bandwidth management rule for other applications or
services, click the Edit icon in the User-defined Service table of the Advanced
screen. The following screen displays.
Figure 150 Bandwidth Management Rule Configuration: User-defined Service Rule
Configuration
Table 78 Bandwidth Management Rule Configuration: Pre-defined Service
LABEL DESCRIPTION
# This is the number of an individual bandwidth management rule.
Enable Select an interface’s check box to enable bandwidth management on
that interface.
Direction These read-only labels represent the physical interfaces. Bandwidth
management applies to all traffic flowing out of the router through the
interface, regardless of the traffic’s source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass
through the NBG-460N and be managed by bandwidth management.
Destination Port This is the port number of the destination. See Appendix E on page 369
for some common services and port numbers.
Source Port This is the port number of the source. See Appendix E on page 369 for
some common services and port numbers.
Protocol This is the protocol (TCP or UDP) used for the service.
OK Click OK to save your customized settings.
Cancel Click Cancel to exit this screen without saving.