User's Manual

Chapter 24 Sys Op Mode
NBG-460N User’s Guide
301
24.4 General Screen
Use this screen to select how you want to use your NBG-460N depending on how
you connect to the Internet.
Figure 185 Maintenance > Sys OP Mode > General
If you select Router Mode, the following pop-up message window appears.
Figure 186 Maintenance > Sys Op Mode > General: Router
• In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN
Ethernet ports have different IP addresses.
• The DHCP server on your device is enabled and allocates IP addresses to other
devices on your local network.
• The LAN IP address of the device on the local network is set to 192.168.1.1.
• You can configure the IP address settings on your WAN port. Contact your ISP
or system administrator for more information on appropriate settings.
If you select Access Point the following pop-up message window appears.
Figure 187 Maintenance > Sys Op Mode > General: AP
•In AP Mode all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled
WAN. There is no WAN port.