User's Manual

Chapter 3 Introducing the Web Configurator
NBG-460N User’s Guide
36
•In Router Mode enable the DHCP Server. The NBG-460N assigns your
computer an IP address on the same subnet.
•In AP Mode, AP + Bridge mode and Bridge mode the NBG-460N does not
assign an IP address to your computer, so you should check it’s in the same
subnet. See Section 6.5 on page 94 for more information.
4 Type "1234" (default) as the password and click Login. In some versions, the
default password appears automatically - if this is the case, click Login.
5 You should see a screen asking you to change your password (highly
recommended) as shown next. Type a new password (and retype it to confirm)
and click Apply or click Ignore.
Figure 10 Change Password Screen
Note: The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes). Simply
log back into the NBG-460N if this happens.
6 Select the setup mode you want to use.
•Click Go to Wizard Setup to use the Configuration Wizard for basic Internet
and Wireless setup.
•Click Go to Basic Setup if you want to view and configure basic settings that
are not part of the wizard setup. Not all Web Configurator screens are
available in this mode. See Chapter 23 on page 297 for more information.
• Click Go to Advanced Setup to view and configure all the NBG-460N’s
settings.