User's Manual

Chapter 3 Introducing the Web Configurator
NBG-460N User’s Guide
43
3.5.2 Summary: Any IP Table
This screen displays the IP address of each computer that is using the NBG-460N
via the any IP feature. Any IP allows computers to access the Internet through the
NBG-460N without changing their network settings when NAT is enabled. To
access this screen, open the Status screen (see Section 3.5 on page 38), and
click (Details...) next to Any IP Table.
Figure 13 Any IP Table
3.5.3 Summary: Bandwidth Management Monitor
Select the BW MGMT Monitor (Details...) hyperlink in Status screen. View the
bandwidth usage of the WAN configured bandwidth rules. This is also shown as
bandwidth usage over the bandwidth budget for each rule. The gray section of the
Logs View Log Use this screen to view the logs for the categories that you
selected.
Log
Settings
Use this screen to change your NBG-460N’s log settings.
Tools Firmware Use this screen to upload firmware to your NBG-460N.
Configuratio
n
Use this screen to backup and restore the configuration or
reset the factory defaults to your NBG-460N.
Restart This screen allows you to reboot the NBG-460N without
turning the power off.
Wake On
LAN
Use this screen to remotely turn on a device on the
network.
Green Use this screen to activate the energy-conserving
feature of your NBG-460N
Config
Mode
General This screen allows you to display or hide the advanced
screens or features.
Sys OP
Mode
General This screen allows you to select whether your device acts
as a Router or a Access Point.
Language Language This screen allows you to select the language you prefer.
Table 5 Screens Summary
LINK TAB FUNCTION