User's Manual

Chapter 5 Tutorials
NBG-460N User’s Guide
78
5.3.1 Configuring Bob’s NBG-460N VPN Settings
To configure these settings Bob uses the NBG-460N Web Configurator.
1 Log into the NBG-460N Web Configurator and click VPN > Modify icon. This
displays the VPN Rule Setup (basic) screen.
2 Select the Active checkbox to enable the VPN rule after it has been created. Make
sure IKE is selected as the IPSec Keying Mode.
Figure 49 Tutorial: Property
3 Enter the IP address “192.168.1.35” in the Local Address text box. This is the IP
address of Bob’s computer. Enter the IP address “192.168.1.35” in the Local
Address End/Mask text box. This value is the same as Bob only wants Jack to
access this single IP address.
Figure 50 Tutorial: Local Policy
4 Enter the IP address “10.0.0.7” in the Remote Address Start text box. This is
the IP address of Jack’s computer. Enter the IP address “10.0.0.7” in the Remote
Address End/Mask text box. This value is the same as Jack only wants Bob to
access this single IP address.
Figure 51 Tutorial: Remote Policy
5 Enter the IP address “1.1.1.1” in the My IP Address text box. This is Bob’s WAN
IP address.
6 Select IP as the Local ID Type. This is the type of content that will be used to
identify Bob’s NBG-460N. Enter the IP address “1.1.1.1” in the Local Content
text box. This identifies Bob’s NBG-460N to Jack’s NBG-460N.