ZyXEL AG-100 802.11a/b/g Wireless CardBus Adapter Quick Start Guide Version 1.
ZyXEL AG-100 Quick Start Guide Important Note Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
ZyXEL AG-100 Quick Start Guide This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
ZyXEL AG-100 Quick Start Guide 1. Installation Requirements Before installation, make sure you have a computer with the following: • Pentium II 300MHz or above • A minimum of 20 MB available hard disk space • 32MB RAM (64MB Recommended) • A CD-ROM drive • A CardBus (PCMCIA Type II) slot • Windows XP/2000/ME/98 SE • Windows 98 SE users may need the Windows 98 SE CD 2. ZyXEL Utility and Hardware Installation The installation procedures are similar for all supported Windows versions.
ZyXEL AG-100 Quick Start Guide 2. Click Install Utility to start installation. 3. Client utility and driver will be automatically installed. 4. You will be prompted to insert your ZyAIR Adapter. 5. Locate an available CardBus slot on the computer. 6. With the pin connectors facing the slot and the LED side facing up, slide the ZyXEL AG-100 into the slot. The LEDs turn on if the ZyXEL AG-100 is properly inserted. ) Never bend, force or twist the ZyXEL AG-100 into the slot. 7.
ZyXEL AG-100 Quick Start Guide 9. Double click the icon to configure your wireless adapter. ) If the ZyXEL Utility icon displays, the ZyXEL AG-100 is installed properly. Refer to the User’s Guide to configure the ZyXEL AG-100. LED Display Power Link The following table describes the LEDs on the ZyXEL AG-100. LED COLOR PWR Green LINK Green STATUS DESCRIPTION On The ZyXEL AG-100 is receiving power. Off The ZyXEL AG-100 is not receiving power. On The ZyXEL AG-100 is connected.
ZyXEL AG-100 Quick Start Guide Troubleshooting PROBLEM Windows does not auto-detect the ZyXEL AG-100. CORRECTIVE ACTION Make sure the ZyXEL AG-100 is properly inserted into the CardBus slot and then restart your computer. Once the computer has restarted, check the status of the LEDs on the ZyXEL AG-100. Perform a hardware scan by clicking Start, Settings, Control Panel and then double-click Add/Remove Hardware. (Steps may vary depending on Windows version).
