ZyWALL 10W Internet Security Gateway Quick Start Guide Version 3.
ZyWALL 10W Internet Security Gateway Hardware Installation Rear Panel and Connections Connect a grounded wire to ground the ZyWALL. Reset to default configuration file. See User’s Guide. Turn off your ZyWALL. Remove the protective cover plate from the slot and insert an optional PCMCIA wireless LAN card into the slot. Connect to your cable/DSL modem. Connect to a computer/hub using a straight-through/ crossover Ethernet cable.
ZyWALL 10W Internet Security Gateway Internet Account Checklist Your ISP (Internet Service Provider) should have given you most of the following information. You do not need to fill in every blank.
ZyWALL 10W Internet Security Gateway 5. The Internet Protocol TCP/IP Properties screen opens (the General tab in Windows XP). -To have your computer accept a dynamic IP address, click Obtain an IP address automatically. -If you want a static IP address, click Use the following IP Address and fill in the IP address (192.168.1.2 to 192.168.1.254), Subnet mask (255.255.255.0), and Default gateway (192.168.1.1) fields. 6. Click Advanced.
ZyWALL 10W Internet Security Gateway Procedure For Web Configurator Configuration 1. Make sure your computer IP address and the ZyWALL IP address are on the same subnet. Refer to the TCP/IP section in your User’s Guide. 2. Launch your web browser and enter “192.168.1.1” as the URL. 3. Enter "1234" (default) as the password and click Login. In some versions, the default password appears automatically - if this is the case, just click Login.
ZyWALL 10W Internet Security Gateway Configuring for Internet Access Configuration Using Web Configurator Wizard 1. Click Wizard Setup in the main menu. Follow the online instructions to configure the first wizard setup screen and click Next. 2. Use the information in the previous Required Information table to enter the related fields in the following screen and click Next. 3. In the following screen, repeat step 2 and click Finish to complete the wizard setup. Configuration Using SMT Menu 4 1. 2.
ZyWALL 10W Internet Security Gateway Activating the Wireless LAN The wireless LAN is disabled by default. Before you enable the wireless LAN you should configure some security, for example, setting MAC address filters and/or 802.1X security; otherwise your LAN will be vulnerable upon enabling it. Setting MAC filters Using the SMT Using the Web Configurator 1. Type 3 in the main menu and press ENTER. 1. 2. Type 5 in Menu 3 – LAN Setup and press ENTER.
ZyWALL 10W Internet Security Gateway Troubleshooting PROBLEM CORRECTIVE ACTION None of the LEDs turn on when you turn on the ZyWALL. Make sure that you have the correct power adapter connected to the ZyWALL and plugged in to an appropriate power source. Cannot access the ZyWALL from the LAN. Check the cable connection between the ZyWALL and your computer or hub. Refer to the Rear Panel and Connections section for details. If the error persists, you may have a hardware problem.
