Toggler Lag Screw Shield (1/2 x 3" / Box of 25)

Mounting fixtures on brick or concrete requires a really strong hold. TOGGLER’s Lag Screw Shields ensure that your screws are properly anchored to hold just about anything. These bad boys last – they’re corrosion resistant and rust-proof. The best part is they’re suitable for both masonry and masonry joints. TOGGLER’s lag screw shields are constructed with zamac alloy. They can be used with almost any material, including: normal weight concrete, lightweight concrete, hollow masonry. and solid masonry. Drill the hole according to its "Drill Dia.". To assure full holding power, do not ream the hole or allow the drill to wobble. Drill the hole deeper than the intended embedment, but not closer than two diameters to the bottom (opposite) surface of the concrete. Clean the hole with a nylon brush and compressed air. Insert the anchor into the hole and tap flush. Position fixture, insert bolt and tighten. In case you were wondering if TOGGLER’s anchors, lags, and screws are suitable for mounting flat panel displ...