Installation guide

8-4 BEA Products Installation Guide
1. Shut down any servers that are running. If any of these servers is configured as a Windows
service, you should stop the service(s) before uninstalling the software.
2. Start the uninstallation program as described in Table 8-2.
3. Press Enter or type
next to proceed to the next panel of the uninstallation program.
Note: Instead of typing complete words when you want to enter
[Exit], [Previous], and
[Next], you can use the following one-letter shortcuts: x, p, and n, respectively.
The Choose Components to uninstall panel is displayed.
4. Select the components you want to uninstall. The available components are displayed as
follows:
Check the BEA Products components you want to uninstall.
Release 9.2.0.0
+----WebLogic Server [1] v
| +----Server [1.1] v
| +----Server Examples [1.2] v
Table 8-2 Starting the Uninstallation Program in Console Mode
To start the uninstallation
program on this platform . . .
Perform the following steps . . .
Windows 1. Open a Command Prompt window and go to the following
directory:
WL_HOME\uninstall
Here WL_HOME represents the directory in which you installed your
WebLogic Server software, typically C:\bea\weblogic92.
2. Enter the following command at the prompt:
uninstall -mode=console
The Welcome text is displayed.
UNIX 1. Go to the following directory:
WL_HOME/uninstall
Here WL_HOME represents the directory in which you installed
WebLogic Server.
2. At the prompt, enter the following command:
sh uninstall.sh -mode=console
The Welcome text is displayed.