User manual - Scripting_Guide

UPC-EAN GENERAL SYMBOLOGY PROPERTIES
UPC-EAN general symbology properties are unique for each session.
Symbology properties begin with “sessionX.scanner.upc-ean” where X is 1
through. For example “session4.scanner.upc-ean.bookland”. If no ‘X’ value is
found, the currently active session number is used.
NOTE: If you are changing the symbology properties for the currently active
session, you must call “CETerm.PostIDA(
“IDA_SCAN_APPLYCONFIG”, 0 ) for the changes to take effect.
WARNING: Not all properties are applicable to all hardware devices. Different
devices may use different names to refer to the same parameters.
You should look at the settings available in the CETerm configuration
dialogs to determine if the property is appropriate and what values it
may accept.
Last Property Level Description
bookland Enable Bookland labels. T/F
coupon Enable Coupon labels. T/F
lineardecode Enable linear decode. T/F
supplemental2 Enable 2 digit supplemental or add-on barcode. T/F
supplemental5 Enable 5 digit supplemental or add-on barcode. T/F
supplementalretry Supplemental decode retry count. 2-10
randomweightcheckdigit Enable random weight check digit. T/F
supplementalmode Supplemental mode. none, always, auto
securitylevel Decode security level. none, all, ambiguous