Command Reference Guide

Throttles down the consistency check to lessen impact on restore performance.
Set the number of input/output operations, after which the check is stopped for
one second.
Exchange_2007_Specific_Options
-appsrv ClientName
Specifies the system to which the components are restored. If not specified, the
components are always restored to the server from where they were backed up.
Note that all objects in one restore session must be restored to the same system.
-target_tree TargetTreeName
Specifies the target component to which the source component will be restored
and enables you to restore a subcomponent to a different component than the
one from which it was backed up. This option can be used only once for each
-tree option and cannot be specified together with -exch_RSG.
TreeName and its TargetTreeName pair must always be fully expanded
subcomponents representing an Exchange store or logs. See also the Exchange
2007 examples. To get a list of available targets on a specific host, run the
command:
vssbar -appsrv:HostName -perfom:browse -all
Potential targets can be identified by the string “RESTOREMODE = 1”.
NOTE: You cannot restore only a store without logs to a different location. If you
specify a target store for an original store, you must also specify logs with an
additional -tree TreeName -target_tree TargetTreeName pair. This
limitation does not apply if you restore only the logs to a different location.
The option must be specified together with -target_dir.
-exch_RSG RSGTreeName
Creates a new Recovery Storage Group (RSG) and links it to RGSTreeName.
This option can be used only once for each -tree option and cannot be specified
together with -target_tree. Only one storage group per session can be
restored with this option due to an Exchange limitation. RSGTreeName and its
TreeName pair must always be fully expanded subcomponents, representing
an Exchange store or logs. See also the Exchange 2007 examples.
IMPORTANT: If the RSG already exists, it is removed and a new one is created.
Any existing data in it will be lost. NOTE: You cannot restore only a store without
logs to a different location. If you specify a target store for an original store, you
must also specify logs with an additional -tree TreeName -target_tree
TargetTreeName pair. This limitation does not apply if you restore only the
logs to a different location.
The option must be specified together with -target_dir.
Command line interface reference 75