HP 3PAR RedHat and Oracle Linux Implementation Guide

For example, to set the HBA ports 1 and 3 to Point to Point/Fabric topology, run the following
commands:
# /opt/Qlogic_Corporation/SANsurferCLI/scli -n 1 CO 1
# /opt/Qlogic_Corporation/SANsurferCLI/scli -n 3 CO 1
To set the same HBA ports 1 and 3 to Direct topology, run the following commands:
# /opt/Qlogic_Corporation/SANsurferCLI/scli -n 1 CO 0
# /opt/Qlogic_Corporation/SANsurferCLI/scli -n 3 CO 0
You can verify the setting by running the following command:
# /opt/Qlogic_Corporation/SANsurferCLI/scli -I 1
# /opt/Qlogic_Corporation/SANsurferCLI/scli -I 3
Refer to the SANsurfer FC CLI utility program release notice for other command line options to
change the following settings:
• LUNs per Target: 256
• Data Rate: 4 (Auto Negotiate)
Installing the Brocade HBA
Install the Brocade host bus adapter(s) (HBAs) in the host in accordance with the documentation
provided with the HBAs and host.
Building the Brocade Driver
NOTE: Use this section only if you are installing and building the Brocade driver. If you are using
the Brocade driver that was installed by the RHEL installation, skip to “Setting up the NVRAM and
BIOS with the Brocade HBA” (page 43).
If you are installing the Brocade driver instead of using the in-box Brocade driver that was already
installed by the RHEL installation, follow these steps:
42 Configuring a Host with Fibre Channel