HP 3PAR OS 3.1.3 Command Line Interface Reference

OPTIONS
-remote
Used to forward a witness subcommand to the be executed on the remote HP 3PAR Storage System.
When used in conjunction with the witness check subcommand the target must be specified
when executing on the local storage system target specification is not required to check connectivity
with the Quorum Witness.
-node
Used to conjunction with the witness check subcommand to test the connectivity to the Quorum
Witness via the Quorum Announce process running on the specified node. Otherwise, the command
simply verifies that there its at least one operational route to the witness.
SPECIFIERS
<target_name>
Specifies the target name for the target definition previously created with the creatercopytarget
command.
<policy>
This specifier can only be used with the pol subcommand. The policy can be one of the following:
mirror_config|no_mirror_config
Specifies that all configuration commands (creatercopygroup, removercopygroup,
admitrcopyvv, dismissrcopyvv, setrcopygroup pol/period, startrcopygroup,
and stoprcopygroup) involving the specified target are duplicated (mirror_config) or not
duplicated (no_mirror_config). If not specified, all configuration commands are duplicated.
NOTE: The no_mirror_config specifier should only be used to allow recovery from an unusual
error condition and only used after consulting your HP representative.
<new_name>
The new name for the indicated target. This specifier can only be used with the name subcommand.
<tput_value>
Specifies the maximum throughput for the indicated target's links, and is used to limit the total
throughput of the links. The throughput value can take a [g|G] suffix (gigabytes), [m|M] suffix
(megabytes) or [k|K] suffix (kilobytes) to indicate size (with no space between the specified value
and size type). The default is kilobytes. Specifying a value of 0 removes the throughput. This
specifier can only be used with the tput subcommand, which only applies to remote copy over
IP (RCIP) configurations.
<bandwidth>
The measured bandwidth of the connection to the target, specified in Kilobytes (KB) per second.
This specifier can only be used with the tunelinks subcommand.
<latency>
The measured round-trip latency of the connection to the target, specified in milliseconds (ms). This
specifier can only be used with the tunelinks subcommand.
<witness_ip>
The IP address of the Quorum Witness (QW) application, to which the HP 3PAR Storage System
will connect to update its status periodically.
308 Set Commands