HP 3PAR Solaris Implementation Guide

WARNING! The SAN version "additions" above are required at a minimum.
HBA Driver/DMP Combinations
Table 8 (page 82) lists Supported HBA driver and DMP combinations.
Table 8 Supported HBA Drivers and DMP Combinations
HBA Driver and DMP Combinations
qla/lpfc + VxDMP with VxVM
qlc/emlxs + VxDMP with VxVM and SSTM
qlc/emlxs + SSTM
qla /lpfc + VxDMP with VxVM + VCS
qlc/emlxs + VxDMP with VxVM + VCS (SSTM not enabled for HP 3PAR)
qlc/emlxs + SSTM + SC
NOTE: SAN packages are installed on all combinations but they are only enabled for SSTM
combinations.
For information about specific HBA/CNA driver and multipath version support, see the HP SPOCK
website:
HP SPOCK
Minimum Requirements for a Valid QLogic qlc + VxDMP Stack
A qlc driver with VxVM 4.1 and above is supported with the following requirements.
SPARC Platform
• Solaris 10 QLC driver patch 143957-03 or later
• Solaris 9 SAN 4.4.x: QLC driver patch 113042-19 or later (SAN 4.4.14)
• Veritas VxVM 4.1MP2_RP3 patch 124358-05 or later (for Solaris 8, 9 and 10)
• Veritas VxVM 5.0MP1_RP4 124361-05 or later (for Solaris 8, 9, and 10)
x86 Platform
• Solaris 10 QLC driver patch 143958-03 or later
• Veritas VM_5.0_RP1_Solx86 (patches 127345-01 and 128060-02) for Solaris 10 x86
Minimum Requirements for a Valid Emulex emlxs + VxDMP Stack
An emlxs (SAN 4.4.1x version and above) driver with VxVM 4.1 and above is supported with the
following requirements.
SPARC Platform
• 120223-27 was the minimum; now 120223-31 emlxs on Sol10
• 119914-13 emlxs on Sol9 (SAN 4.4.14)
• 119913-13 emlxs on Sol8 (SAN 4.4.13)
82 Patch/Package Information