HP VPN Firewall Appliances Network Management Configuration Guide

873
Ste
p
Command Remarks
5. Configure the register suppression
time.
register-suppression-timeout
interval
Optional.
60 seconds by default.
6. Configure the register probe time.
probe-interval interval
Optional.
5 seconds by default.
Configuring switchover to SPT
Both the receiver-side DR and the RP can periodically check the traffic rate of passing-by IPv6 multicast
packets and thus trigger a switchover from RPT to SPT.
Perform the following configuration on routers that might become receiver-side DRs and on C-RP routers.
To configure switchover to SPT:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Enter IPv6 PIM view.
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Optional.
By default, the device switches to the SPT
immediately after it receives the first IPv6
multicast packet from the RPT.
Configuring IPv6 PIM-SSM
IPv6 PIM-SSM model needs the support of MLDv2. Be sure to enable MLDv2 on IPv6 PIM routers with
receivers attached to them.
IPv6 PIM-SSM configuration task list
Task Remarks
Enabling IPv6 PIM-SM Required.
Configuring the IPv6 SSM group range Optional.
Configuring common IPv6 PIM features Optional.
Configuration prerequisites
Before you configure IPv6 PIM-SSM, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
• Determine the IPv6 SSM group range.