HP VPN Firewall Appliances Network Management Configuration Guide

902

The SSM group range is FF3E::/64.

MLDv2 runs between the firewall and N1, and between Router A, Router B, and N2.

Figure 410 Network diagram

Table 83 Interface and IPv6 address assignment

Device Interface IPv6 address

Device

Interface IPv6 address

Firewall GE0/1 1001::1/64 Router C Eth1/1 4001::1/64

Firewall GE0/2 1002::1/64 Router C Eth1/2 1002::2/64

Firewall GE0/3 1003::1/64 Router C POS5/0 4002::1/64

Router A Eth1/1 2001::1/64 Router D POS5/0 3001::2/64

Router A POS5/0 2002::1/64 Router D POS5/1 2002::2/64

Router B Eth1/1 2001::2/64 Router D Eth1/1 1003::2/64

Router B POS5/0 3001::1/64 Router D POS5/3 4002::2/64

Configuration procedure

1. Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing:

a. Enable IPv6 forwarding on each router and configure the IPv6 address and prefix length for

each interface according to Figure 410. (Details not shown.)

b. Configure OSPFv3 on the routers in the IPv6 PIM-SS

M domain to make sure they are

interoperable at the network layer. (Details not shown.)

2. Enable IPv6 multicast routing, MLD and IPv6 PIM-SM:

# On the firewall, enable IPv6 multicast routing globally, enable MLDv2 on GigabitEthernet 0/1,

and enable IPv6 PIM-SM on each interface.

GE0/2Eth1/