Managing MC/ServiceGuard NFS for Linux, December 2001

Installing and Configuring MC/ServiceGuard NFS for Linux
Configuring a MC/ServiceGuard NFS Package
Chapter 2 25
Configuring a MC/ServiceGuard NFS Package
To configure a MC/ServiceGuard NFS package, complete the following
tasks, described in this section:
• Editing the Package Configuration File (pkg.conf)
• Editing the Package Control Scripts (pkg.cntl)
• Editing the NFS Control Script (hanfs.sh)
• Creating the MC/ServiceGuard Binary Configuration File
NOTE Repeat the configuration process for each NFS package.
Editing the Package Configuration File (pkg.conf)
The following steps describe the required modifications to the Package
Configuration File. Make one Package Configuration file for each
package.
1. Except for the variables listed below, use the default values for the
variables in the package configuration file, or change them as
needed.
For instructions on modifying the default values, see the Managing
MC/ServiceGuard manual, or read the comments in the package
configuration file.
2. Set the PACKAGE_NAME variable. For example:
PACKAGE_NAME pkg01
You can use the default package name if you are planning to run only
one MC/ServiceGuard NFS package on your MC/ServiceGuard
cluster. Each package must have a unique name.
3. Create a NODE_NAME variable for each node that will run the package.
The first NODE_NAME should specify the primary node. All the
NODE_NAME variables following the primary node should specify the
adoptive nodes, in the order in which they will be tried. For example: