HP Systems Insight Manager 7.1 Installation and Configuration Guide for MS Windows

NOTE: You can add an unlimited number of trusted certificates.
NOTE: To delete a certificate, select the certificate, and click Delete. The selected
certificate is removed.
5. From the IP Binding window, select the Enable IP Binding checkbox if you would like
to bind to IP addresses that match a specific subnet and mask. Click Next.
6. From the IP Restricted Logins window, select the Enable IP Restricted Logins checkbox
if you would like to include or exclude specific IP addresses or IP address ranges.
Click Next, and the Summary Panel appears.
7. Click to continue to the Summary Panel.
Trust By Name
1. Select Trust By Name. Click Next. The Trusted Server window appears. Enter the
names of the servers you want to trust.
Although the Trust By Name mode is a slightly stronger method of security than the
Trust All mode, it still leaves your system vulnerable to security attacks. The Trust By
Name mode sets up the HP System Management Homepage to only accept certain
requests from servers with the Systems Insight Manager names designated in the
Trust By Name field. The Trust By Name option is easy to configure and can prevent
non-malicious access. For example, you might want to use the Trust By Name option
if you have a secure network, but your network has two groups of administrators in
two separate divisions. The Trust By Name option would prevent one group from
installing software to the wrong system. This option does not verify anything other
than the Systems Insight Manager server name submitted.
NOTE: The server name cannot contain the following characters:
~ ! ` @ # $ % ^ & * ( ) + = " : ' < > ? , | ;
2. Click Add to add the name of a server you want to trust. Click Next.
NOTE: If you click Next without adding any server names to the list, an error
message appears indicating that if you do not specify any trusted server names,
Systems Insight Manager cannot access the Insight Management Agent on this system.
Click OK to proceed without trusting any systems, or click Cancel to close the window
and add server names to the list. In the HP SMH interface, if you do not enter an
Systems Insight Manager name (host name) the Apply button will not be enabled,
however during HP SMH installation the installation will continue after displaying
the error message.
NOTE: To delete a certificate, select the certificate, and click Delete. The selected
certificate is removed.
3. From the IP Binding window, select the Enable IP Binding checkbox if you would like
to bind to IP addresses that match a specific subnet and mask. Click Next.
4. From the IP Restricted Logins window, select the Enable IP Restricted Logins checkbox
if you would like to include or exclude specific IP addresses or IP address ranges.
Click Next, and the Summary Panel appears.
5. Click to continue to the Summary Panel.
Trust All
1. Select Trust All. Click Next. The IP Binding window appears.
2. Select the Enable IP Binding checkbox if you would like to bind to IP addresses that
match a specific subnet and mask. Click Next.
Custom install 73