Systems Insight Manager 6.2 Installation and Configuration Guide for MS Windows

4. Verify the certificate information. If you want to add this certificate to the Trusted Certificate
List, click Accept and the certificate is added to the Trusted Certificate List, or click Cancel
if you do not want to add it to the Trusted Certificate List. The Trusted Cer tificate List
appears. Click Next.
NOTE: You can add an unlimited number of trusted certificates.
NOTE: To delete a certificate, select the certificate, and click Delete. The selected certificate
is removed.
5. From the IP Binding window, select the Enable IP Binding checkbox if you would like to
bind to IP addresses that match a specific subnet and mask. Click Next.
6. From the IP Restricted Logins window, select the Enable IP Restricted Logins checkbox
if you would like to include or exclude specific IP addresses or IP address ranges. Click Next,
and the Summary Panel appears.
7. Click to continue to the Summary Panel.
Trust By Name
1. Select Trust By Name. Click Next. The Trusted Server window appears. Enter the names
of the servers you want to trust.
Although the Trust By Name mode is a slightly stronger method of security than the Trust
All mode, it still leaves your system vulnerable to security attacks. The Trust By Name mode
sets up the System Management Homepage to only accept certain requests from servers with
the HP Systems Insight Manager names designated in the Trust By Name field. The Trust
By Name option is easy to configure and can prevent non-malicious access. For example,
you might want to use the Trust By Name option if you have a secure network, but your
network has two groups of administrators in two separate divisions. The Trust By Name
option would prevent one group from installing software to the wrong system. This option does
not verify anything other than the HP Systems Insight Manager server name submitted.
NOTE: The server name cannot contain the following characters:
~ ! ` @ # $ % ^ & * ( ) + = " : ' < > ? , | ;
2. Click Add to add the name of a server you want to trust. Click Next.
NOTE: If you click Next without adding any server names to the list, an error message
appears, indicating that if you do not specify any trusted server names, HP Systems Insight
Manager cannot access the Insight Management Agents on this system. Click OK to proceed
without trusting any systems, or click Cancel to close the window and add server names to
the list. In the SMH interface, if you do not enter an HP Systems Insight Manager name (host
name) the Apply button will not be enabled, however during SMH installation the installation
will continue after displaying the error message.
NOTE: To delete a certificate, select the certificate, and click Delete. The selected certificate
is removed.
3. From the IP Binding window, select the Enable IP Binding checkbox if you would like to
bind to IP addresses that match a specific subnet and mask. Click Next.
4. From the IP Restricted Logins window, select the Enable IP Restricted Logins checkbox
if you would like to include or exclude specific IP addresses or IP address ranges. Click Next,
and the Summary Panel appears.
5. Click to continue to the Summary Panel.
Trust All
1. Select Trust All. Click Next. The IP Binding window appears.
2. Select the Enable IP Binding checkbox if you would like to bind to IP addresses that match
a specific subnet and mask. Click Next.
NOTE: The Trust All option leaves your system vulnerable to security attacks and sets up
the System Management Homepage to accept certain requests from any server. For example,
Custom install 57