HP-UX Secure Shell A.04.30.006 and A.04.30.007 Release Notes

HP-UX Secure Shell A.04.30.006 and A.04.30.007
Installing HP-UX Secure Shell
Chapter24
Installing HP-UX Secure Shell
You do not need to remove any previous versions of HP-UX Secure Shell
before upgrading to HP-UX Secure Shell A.04.30.006 and A.04.30.007.
However, if you are reverting to an older version of HP-UX Secure Shell,
HP recommends that you remove the new product before reverting to the
older version.
To install HP-UX Secure Shell, complete the following steps:
Step 1. Log in as superuser.
Step 2. Insert the software CD into the appropriate drive if installing from the
Application Release CD. If installing from http://software.hp.com,
download the depot and use the swinstall directions provided on the
Installation page where you downloaded the software.
Step 3. Run $ swinstall -s <fully-qualified depot source path> at the
command prompt.
Step 4. In the Source Depot Path field, enter the drive mount point and click
OK. Change the Source Host Name, if needed.
Step 5. Select T1471AA from the list of available software, and click Mark for
Install on the Actions menu.
Step 6. Click Install on the Actions menu.
Step 7. Click OK in the Install Analysis window when the Status field displays a
Ready message.
Step 8. Click Yes. The swinstall command loads the HP-UX Secure Shell files
on the system in approximately 3 to 5 minutes.
NOTE The sshd daemon is preconfigured, and it is started after installation.
The swinstall command installs HP-UX Secure Shell in the /opt/ssh/
directory.