HP-UX Secure Resource Partitions (SRP) A.02.01 Administrator's Guide

40
physical
memory
value is specified in megabytes.
Variable Name: prm_phys_mem.
Default: 0 (no dedicated physical memory).
6.1.3.2 Configuration Data
By default, SRP creates a new PRM group using the SRP compartment name as the PRM group name.
By default, the PRM group information is stored in the /etc/prmconf file. You can change the
filename by running the srp_setup utility, as described in 2 Setting Up an SRP.
6.1.4 The network Service
The network service configures an IP interface for the SRP compartment.
You do not have to use a dedicated network interface card for the compartment; you can create a
logical IP interface on a network interface card.
6.1.4.1 Input Data
SRP prompts for the following data. You can also specify a variable name and value in the command
line, as described in
13.1 Creating an SRP Compartment or Adding Data to a Compartment.
IP address
Specifies the IP address for the compartment. You must specify a new IP address,
or one that is not included in the definition of any compartment on the system.
Variable Name: ip_address.
Valid Input: An IPv4 address in dotted-decimal notation or an IPv6 address in
colon-hexadecimal notation.
Default: None.
Network
interface
name
Specifies the primary or secondary network interface name for the IP interface. A
primary network interface name has no IP index number or an IP index number set
to 0 (such as lan 2 or lan2:0). A secondary network name has a non-zero IP
index number (such as lan2:1). Secondary interfaces share the same physical
network interface as the corresponding primary interface. If you specify a primary
network interface that is already configured for IP, SRP configures a secondary
interface for you.
If you specified an existing IP address (an IP address that is already configured on
the system) for the ip_address variable , srp uses the interface name with the
configured address and does not prompt you for the network interface name.
Variable Name: iface.
Default: None.
IP subnet
mask
(Valid for IPv4 addresses only) Specifies the subnet mask for the interface, in
dotted-decimal notation.
Variable Name: ip_mask.
Default: The network mask for the address class, as specified in RFC 791.
Default
gateway IP
Address
IP address to use for routing network packets for the configured compartment IP
address. The value is an IPv4 address in dotted-decimal notation or an IPv6
address in colon-hexadecimal notation.
Variable Name: gw_ip_address
Default: ip_addresss ( IP address configured for this compartment)
Assign IP
address at
Configure IP address in network configuration