HP Virtual Connect Manager Command Line Interface Version 3.00 User for Integrity BL8x0c i2 Server Blades Guide

Command line 80
Name RFC Description
ExceededDiscards by this port due to an excessive
size. It is incremented by both
transparent and source route
bridges.
rfc1213_Dot1dPortInDiscard
s
1493
Count of valid frames received
which were discarded (i.e.,
filtered) by the Forwarding
Process.
rfc1213_Dot1dTpPortInFram
es
1493
The number of frames that have
been received by his port from its
segment. Note that a frame
received on the interface
corresponding to this port is only
counted by this object if and only
if it is for a protocol being
processed by the local bridging
function, including bridge
management frames.
rfc1757_StatsBroadcastPkts 1757
The number of good packets
received during this sampling
interval that were directed to the
broadcast address
rfc1757_StatsCRCAlignError
s
1757
The total number of packets
received that had a length
(excluding framing bits, but
including FCS octets) of between
64 and 1518 octets, inclusive, but
but had either a bad Frame Check
Sequence (FCS) with an integral
number of octets (FCS Error) or a
bad FCS with a non-integral
number of octets (Alignment
Error).
rfc1757_StatsCollisions 1757
The best estimate of the total
number of collisions n this Ethernet
segment. The value returned will
depend on the location of the
RMON probe. Section 8.2.1.3
(10BASE-5) and section 10.3.1.3
(10BASE-2) of IEEE standard
802.3 states that a station must
detect a collision, in the receive
mode, if three or more stations are
transmitting simultaneously. A
repeater port must detect a
collision when two or more
stations are transmitting
simultaneously. Thus a probe
placed on a repeater port could
record more collisions than a
probe connected to a station on
the same segment would.