HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

DescriptionStatusParameter name
Controller ID of the port controller in the storage system
Specify this parameter when you want to obtain information about
a specific port controller. If you specify this parameter, you must
also specify the model and serialnum parameters. If
controllernum and controllername are omitted, port
controller information is obtained for the specified storage system.
Do not specify controllernum and controllername at the
same time. If they are specified at the same time, an error will
occur.
Optional
controllernum
Controller name for port controller of storage system
Specify this parameter when you want to obtain information about
a specific port controller. If you specify this parameter, you must
also specify the model and serialnum parameters. If
controllernum and controllername are omitted, port
controller information is obtained for the specified storage system.
Do not specify controllernum and controllername at the
same time. If they are specified at the same time, an error will
occur.
Optional
controllername
Specific information about the port controller you intend to obtain
Available values are IPAddress and
PairedPortController. You can specify either one or both
of these values.
The information about IPAddress and
PairedPortController is valid for the NAS configuration.
Optional
controller-
subinfo
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
controllernum
Obtain this value from the execution result of the GetStorageArray (subtarget=PortCon-
troller) command. Execute this command by specifying only the model and serialnum
parameters, and the value for subtarget=PortController. In the execution result of this
command, the controllerID value appears under An instance of PortController.
Use this controllerID value to specify the controllernum parameter.
controllername
Obtain this value from the execution results of the GetStorageArray (subtarget=PortCon-
troller) command. In the execution results, displayName is displayed below An instance
of PortController. Specify this value as controllername.
Command execution example 1
In this example, the GetStorageArray (subtarget=PortController) command obtains
information about port controllers used for a storage system (serial number: 10001, model: XP1024).
Command reference174