Hitachi Dynamic Link Manager Software Users Guide for Linux

20. Delete the initial RAM disk image file for HDLM that was created with the
dlmmkinitrd utility for supporting a boot disk or the dracut command.
To do this, execute the following command:
¢
When an IA32 host is used:
# rm /boot/initrd-hdlm-2.6.9-55.EL.img
¢
When an IPF host is used:
# rm /boot/efi/efi/redhat/initrd-hdlm-2.6.9-55.EL.img
21. Remove HDLM.
To remove HDLM, execute the following command:
# rpm -e HDLM
22. Make sure that the removal has been completed.
You must execute the following command to make sure that the removal
has been completed. The following information is output.
# rpm -qi HDLM
package HDLM is not installed
Removing Hitachi Network Objectplaza Trace Library (HNTRLib2)
When you remove HDLM, if the KAPL09019-E or KAPL09020-E message is
output, follow the directions below to remove HNTRLib2.
To remove HNTRLib2:
1. Log in to Linux as the root user.
2. Execute the following command to unregister the name of the bundled
program products.
# /opt/hitachi/HNTRLib2/etc/hntr2cancel "Hitachi Dynamic Link
Manager"
3. Execute the following command.
# /opt/hitachi/HNTRLib2/etc/hntr2setup
The HNTRLib2 setup menu will appear.
4. From the Setup menu, select 9.
HNTRLib2 will be removed.
If HNTRLib2 is not being used by any other programs:
HNTRLib2 will be removed normally, and the following message will
appear.
Unsetup is complete.
If HNTRLib2 is being used by another program:
Creating an HDLM Environment
3-231
Hitachi Dynamic Link Manager (for Linux®) User Guide