Specifications

Chapter 6 - Samples
Previous page Table of contents Chapter overview Next page
Optocoupler
Optocoupler combine a LED and photo-transistor in the same case. The purpose of an optocoupler
is to separate two parts of a circuit.
This is done for a number of reasons:
● Interference. One part of a circuit may be in a location where it picks up a lot of
interference (such as from electric motors, welding equipment, petrol motors etc.) If the
output of this circuit goes through an optocoupler to another circuit, only the intended
signals will pass through the optocoupler. The interference signals will not have enough
"strength" to activate the LED in the optocoupler and thus they are eliminated. To protect a
section of the device. Typical examples are industrial units with lots of interferences which
affect signals in the wires. If these interferences affect the function of control section, errors
will occur and the unit will stop working.
● Simultaneous separation and intensification of a signal. A signal as low as 3v is able
to activate an optocoupler and the output of the optocoupler can be connected to an input
line of a microcontroller. The microcontroller requires an input swing of 5v and in this case
the 3v signal is amplified to 5v. It can also be used to amplify the current of a signal. See
below for use on the output line of a microcontroller for current amplification.
● High Voltage Separation. Optocouplers have inherent high voltage separation qualities.
Since the LED is completely separate from the photo-transistor, optocouplers can exhibit
voltage isolation of 3kv or higher.
Optocouplers can be used as input or output device. They can have additional functions such as
Schmitt triggering (the output of a Schmitt trigger is either 0 or 1 - it changes slow rising and
falling waveforms into definite low or high values). Optocouplers are packaged as a single unit or
in groups of two or more in one housing. They are also called PHOTO INTERRUPTERS where a
spoked wheel is inserted in a slot between the LED and phototransistor and each time the light is
interrupted, the transistor produces a pulse.
Each optocoupler needs two supplies in order to function. They can be used with one supply, but
the voltage isolation feature is lost.
Optocoupler on an input line
The way it works is simple: when a signal arrives, the LED within the optocoupler is turned on,
and it shines on the base of a photo-transistor within the same case. When the transistor is
activated, the voltage between collector and emitter falls to 0.5V or less and the microcontroller
sees this as a logic zero on its RA4 pin.
The example below is a counter, used for counting products on production line, determining motor
speed, counting the number of revolutions of an axis etc.
Let the sensor be a micro-switch. Each time the switch is closed, the LED is illuminated. The LED
'transfers' the signal to the phototransistor and the operation of the photo-transistor delivers a
LOW to input RA4 of a microcontroller. A program in the microcontroller will be needed to prevent
false counting and an indicator connected to any of the outputs of the microcontroller will shows
the current state of the counter.
http://www.mikroelektronika.co.yu/english/product/books/PICbook/6_05Poglavlje.htm (1 of 3) [4/2/2003 16:18:52]