Computer Hardware User Manual

Glossary
544
increment Increasing a numeric value.
indirect address An address whose contents indicates another address. The contents of the se-
cond address will be used as the operand. Indirect addressing is possible in the
DM area only.
initialization error An error that occurs either in hardware or software during the PC System start-
up, i.e., during initialization.
initialize Part of the startup process whereby some memory areas are cleared, system
setup is checked, and default values are set.
input The signal coming from an external device into the PC. The term input is often
used abstractly or collectively to refer to incoming signals.
input bit A bit in the IR area that is allocated to hold the status of an input.
input device An external device that sends signals into the PC System.
input point The point at which an input enters the PC System. Input points correspond
physically to terminals or connector pins.
input signal A change in the status of a connection entering the PC. Generally an input signal
is said to exist when, for example, a connection point goes from low to high volt-
age or from a nonconductive to a conductive state.
instruction A direction given in the program that tells the PC of an action to be carried out,
and which data is to be used in carrying out the action. Instructions can be used
to simply turn a bit ON or OFF, or they can perform much more complex actions,
such as converting and/or transferring large blocks of data.
instruction block A group of instructions that is logically related in a ladder-diagram program. Al-
though any logically related group of instructions could be called an instruction
block, the term is generally used to refer to blocks of instructions called logic
blocks that require logic block instructions to relate them to other instructions or
logic blocks.
instruction execution time The time required to execute an instruction. The execution time for any one
instruction can vary with the execution conditions for the instruction and the op-
erands used within it.
instruction line A group of conditions that lie together on the same horizontal line of a ladder dia-
gram. Instruction lines can branch apart or join together to form instruction
blocks.
interface An interface is the conceptual boundary between systems or devices and usual-
ly involves changes in the way the communicated data is represented. Interface
devices such as NSBs perform operations like changing the coding, format, or
speed of the data.
interlock A programming method used to treat a number of instructions as a group so that
the entire group can be reset together when individual execution is not required.
An interlocked program section is executed normally for an ON execution condi-
tion and partially reset for an OFF execution condition.
interrupt (signal) A signal that stops normal program execution and causes a subroutine to be run.
Interrupt Input Unit A Rack-mounting Unit used to input external interrupts into a PC System.