Manualshelf

Data Sheet

ManualsBrandsArduino ManualsArduinoArduino Uno REV3 SMD
51525354555657585960
59
8161D–AVR–10/09
ATmega48PA/88PA/168PA/328P
11.2 Interrupt Vectors in ATmega88PA
Notes: 1. When the BOOTRST Fuse is programmed, the device will jump to the Boot Loader address at reset, see ”Boot Loader Sup-
port – Read-While-Write Self-Programming, ATmega88PA, ATmega168PA and ATmega328P” on page 277.
2. When the IVSEL bit in MCUCR is set, Interrupt Vectors will be moved to the start of the Boot Flash Section. The address of
each Interrupt Vector will then be the address in this table added to the start address of the Boot Flash Section.
Table 11-3 on page 60 shows reset and Interrupt Vectors placement for the various combina-
tions of BOOTRST and IVSEL settings. If the program never enables an interrupt source, the
Interrupt Vectors are not used, and regular program code can be placed at these locations. This
is also the case if the Reset Vector is in the Application section while the Interrupt Vectors are in
the Boot section or vice versa.
Table 11-2. Reset and Interrupt Vectors in ATmega88PA
Vector No.
Program
Address
(2)
Source Interrupt Definition
1 0x000
(1)
RESET
External Pin, Power-on Reset, Brown-out Reset and Watchdog System Reset
2 0x001 INT0 External Interrupt Request 0
3 0x002 INT1 External Interrupt Request 1
4 0x003 PCINT0 Pin Change Interrupt Request 0
5 0x004 PCINT1 Pin Change Interrupt Request 1
6 0x005 PCINT2 Pin Change Interrupt Request 2
7 0x006 WDT Watchdog Time-out Interrupt
8 0x007 TIMER2 COMPA Timer/Counter2 Compare Match A
9 0x008 TIMER2 COMPB Timer/Counter2 Compare Match B
10 0x009 TIMER2 OVF Timer/Counter2 Overflow
11 0x00A TIMER1 CAPT Timer/Counter1 Capture Event
12 0x00B TIMER1 COMPA Timer/Counter1 Compare Match A
13 0x00C TIMER1 COMPB Timer/Coutner1 Compare Match B
14 0x00D TIMER1 OVF Timer/Counter1 Overflow
15 0x00E TIMER0 COMPA Timer/Counter0 Compare Match A
16 0x00F TIMER0 COMPB Timer/Counter0 Compare Match B
17 0x010 TIMER0 OVF Timer/Counter0 Overflow
18 0x011 SPI, STC SPI Serial Transfer Complete
19 0x012 USART, RX USART Rx Complete
20 0x013 USART, UDRE USART, Data Register Empty
21 0x014 USART, TX USART, Tx Complete
22 0x015 ADC ADC Conversion Complete
23 0x016 EE READY EEPROM Ready
24 0x017 ANALOG COMP Analog Comparator
25 0x018 TWI 2-wire Serial Interface
26 0x019 SPM READY Store Program Memory Ready