Manual

Live View Introduction
31
5.3 POS Settings
Some models may not support this function.
①
②
③
④
Click StartSettingsBasicPOS Settings to go to the interface.
Enable POS and click configure under “Connection Settings” to go to the
following interface.
Enter the IP address of the POS you want to add.
Check “Filter destination”, “Filter POS port” and “Filter destination Port” (If
you do not check them, please skip this step) and enter the destination IP, POS
port and destination port you want to filter.
⑤
Click “Display Position” under “Display Settings” to set the position of the
POS information (Use the default settings of the general settings).
⑥
Check “Trigger Camera” and click configure under it to bind POS to the
camera. One POS can be bound to multiple channels, but one channel can only
be bound to one POS