Specifications

46 Input/Output Controller Replacement Instructions
Additional Information
Note Flash memory cards do not insert all the way into the PCMCIA slots on the I/O
controller; the end of the card protrudes from the I/O controller faceplate. Do not attempt
to force the card past this point.
Some older Flash memory cards might have foil tape attached to the outside edge of the
card. If you insert one of these Flash cards into the upper PCMCIA slot (slot 1) of an I/O
controller installed in a Cisco uBR7200 series router, it might be difficult to remove the
card. You should either use a new Flash memory card that does not have the foil tape,
remove the foil tape from the older Flash card, or if necessary, use small pliers to remove
the Flash card.
This completes the procedure for installing a Flash memory card in either PCMCIA slot.
To remove a Flash memory card from either PCMCIA slot, complete the following steps:
Step 1 Press the ejector button on the slot. (See Figure 31c.)
Step 2 Grasp the card and pull it from the slot.
Step 3 Place the card in an antistatic bag.
This completes the procedure for removing a Flash memory card in either PCMCIA slot.