Manual Chapter 5

6-41
Quick Spec
30
Press Enter to continue and return to the initial Quick Spec Screen.
31
Using Quick Spec data to align a machine – selecting Align Machine
takes you directly into the normal alignment mode. To return to Quick
Spec, simply clear the current job. If you wish to calculate the moves, then
complete the job definition and go directly to the Machine Moves selection.
Note
If soft foot has not been corrected previously on this machine,
you will want to check for soft foot before making any moves.
If a soft foot is corrected after the Quick Spec data was taken,
you will want to take a new set of alignment data from which
to calculate the moves.