Manualshelf

User Manual

ManualsBrandsComputerized Security Systems ManualsElectronicsModular Transmitter
12
Responsibilities to comply with FCC and Industry Canada Regulations
The 2.4GHz Module has been certified for integration into products only controlled by Computer
Security Systems, Inc d.b.a. Saflok under the following conditions:
1. The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. The antenna approved for this device is the Johanson Technology ceramic chip
antenna, part number 2450AT43B100.
As long as the conditions above are met, further transmitter testing will not be required.
However, Computer Security Systems, Inc. d.b.a. Saflok is still responsible for testing their end-
product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry Canada
authorizations are no longer considered valid and the FCC ID and IC Certification Number
cannot be used on the final product. In these circumstances, the integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC and Industry Canada authorization.
End Product Labeling
The 2.4GHz Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC
Certification Number are not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the
following:
“Contains Transmitter Module FCC ID: SAPMESSENGEREM”
“Contains Transmitter Module IC: 7078A-A28990”
or
“Contains FCC ID: SAPMESSENGEREM”
“Contains IC: 7078A-A28990”
The Computer Security Systems, Inc d.b.a. Saflok of the 2.4GHz Module must only use the approved
antenna(s) listed above, which have been certified with this module.