Deployment Guide

88
system clock command
Allows the user to configure current system time and date.
Examples
FJ6K0Z1_console> system clock
Incomplete command!
possible subcommands:
date set the system date
time set the system time
system locate command
Starts a beacon timer running for the specified number of seconds to allow the ystem to be located in the
racks.
Examples
FJ6K0Z1_console> system locate
system locate <time in seconds (1-300)>
Activate's the switch's blinking locate LED function for the alloted amount
of time. This can assist a user in locating the switch among other hardware.
FJ6K0Z1_console> system locate 30
unmount command
Allows the user to unmount the device from the system. It shows an informational message if the device
is not mounted but causes no other problems.
unmount unmount usb device
Examples
Shows no message if usb device was mounted:
FJ6K0Z1_console> unmount
unmount <subcommand>
possible subcommands:
usb prepare the usb drive for safe removal
FJ6K0Z1_console> unmount usb
Shows following message if usb device was not mounted:
FJ6K0Z1_console> unmount usb
umount: can't umount /media: Invalid argument
write
Use the write command to write the contents of the running-config to the backup-config.