Command Line Reference Guide

Usage
Information
To configure the switch as a SCP server, use the ip ssh server command.
Related
Commands
ip ssh server – enables the SSH and SCP server on the switch.
ip ssh authentication-retries
Configure the maximum number of attempts that should be used to authenticate a user.
S5000
Syntax
ip ssh authentication-retries 1-10
Parameters
1-10 Enter the number of maximum retries to authenticate a user. The
range is 1 to 10. The default is 3.
Defaults 3
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command specifies the maximum number of attempts to authenticate a user on a SSH
connection with the remote host for password authentication. SSH disconnects when the
number of password failures exceeds authentication-retries.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
S5000
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10 Enter the number of maximum number of incoming SSH connections
allowed per minute. The range is 1 to 10 per minute. The default is 10
per minute.
Defaults 10 per minute
Command Modes CONFIGURATION
1158