Command Line Reference Guide

If you are configuring only one area in your network, you do not need to run both Level 1 and
Level 2 routing algorithms. You can configure the IS type as Level 1.
log-adjacency-changes
Generate a log messages for adjacency state changes.
S5000
Syntax
log-adjacency-changes
To disable this function, use the no log-adjacency-changes command.
Defaults Adjacency changes are not logged.
Command Modes ROUTER ISIS
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command allows you to monitor adjacency state changes, which is useful when you
monitor large networks. Messages are logged in the system’s error message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
S5000
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2]
interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the configuration
to generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the configuration
to generation of Level-2 LSPs.
interval seconds Enter the maximum number of seconds between LSP generations.
The range is 0 to 120 seconds. The default is 5 seconds.
initial_wait_interv
al seconds
(OPTIONAL) Enter the initial wait time, in seconds, before running the
first LSP generation. The range is 0 to 120 seconds. The default is 1
second.
779