Command Line Reference Guide

bit (OPTIONAL) For TCP protocol type only, enter one or a combination of
the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports
for the port command parameter.)
Defaults none
Command Modes REDIRECT-LIST
Command History
Version 9.0(1.3) Introduced on the S5000.
redirect
Configure a rule for the redirect list.
S5000
Syntax
redirect {ip-address} {ip-protocol-number | protocol-type
[bit]} {source mask | any | host ip-address} {destination mask
| any | host ip-address} [operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• You can also use the no redirect {ip-address} {ip-protocol-
number [bit] | protocol-type} {source mask | any | host
ip-address} {destination mask | any | host ip-address}
[operator] command.
Parameters
ip-address Enter the IP address of the forwarding router.
972