Installation Guide

Chapter 2: Advanced Programming
32
[09] - [✱]+[2] Trouble Display
This function key provides the user with a simple method for entering the Trouble
Display Mode (see [*] [2] Trouble Announcements on page 27).
[10] - [✱]+[3] Alarm Memory
This function key provides the user with a simple method for entering the Alarm
Memory Display Mode (see [*] [3] Alarm Memory on page 28).
[11] - [✱]+[5] Programming Access Codes
This function key provides the user with a simple method for programming access
codes. After this key is pressed a valid System Master or Supervisor Code will have
to be entered before the system will allow programming to be performed (see [*]
[5] Programming Access Codes on page 29).
[12] - [✱]+[6] User Functions
This function key provides the user with a simple method for programming User
Functions. After this key is pressed a valid System Master or Supervisor code must
be entered before the system will allow User Functions to be performed (see [*]
[5] Programming Access Codes on page 29).
[13] - [15] For future use
[16] - [✱]+[0] Quick Exit
Pressing this key will cause the system to activate the Quick Exit feature (see section
[*] [0] Quick Exit on page 30).
[17] - [✱]+[1] Reactivate Stay/Away Zones
This function key provides the user with a simple method for adding Stay/Away
zones back into the system (see [*] [1] Zone Bypassing on page 27).
[18] - [26] For future use
[27] - Status
Press this key to have the NT9010 announce the time and the current status of the
system. For example, the system may announce:
“Zones are open. Zone 1. Secure system before turning on. For more options,
press [✱].”
Pressing this key while the unit is speaking will cause the unit to stop speaking.
[28] - Volume
To change the volume of NT9010 announcements, press this key. The NT9010 will
announce the different volume levels.
[29] - Record
Press this key to begin recording a message through the NT9010 microphone. After
you hear the prompt “Record Memo Now” and a single 1 second tone, begin
recording your message. When you are finished recording, press [#].
[30] - Playback
Press this key to listen to a recorded message. If there is no message recorded, the
NT9010 will sound an error tone. You can stop playback of the recorded memo any
time by pressing [#].