Gigabit Router Configuration Guide

Hitachi Gigabit Router GR2000 SeriesEnhanced Version Configuration Commands, Vol. 2
5-20 GR2K-GA-0014
Ver. 07-02
5.5 Routing Protocol
Table 5-5 Routing Protocol Error Messages
Message Contents
aggregate: duplicate AS path pattern in list In the aggregate definition, an AS path is duplicated. Specify a
unique AS path.
aggregate: duplicate autonomous-system in
list at <As>
In the aggregate definition, an AS number is duplicated. Specify a
unique AS number.
<As>: Specified AS number
aggregate: duplicate entry at <Address> mask
<Mask> [exact | refine]
In the aggregate definition, a network range is duplicated. Specify a
unique network range.
<Address>: Specified address
<Mask>: Specified Mask
aggregate: duplicate tag in last at <Tag> In the aggregate definition, a tag is duplicated. Specify a unique tag.
<Tag>: Specified tag
aggregate: invalid autonomous system value
at <value> not in range 1 to 65534
AS number is invalid. Specify a value within the range of 1 to 65534.
<Value>: Specified AS number
aggregate: invalid external-route-tag value at
<Value> not in range 0 to 2147483647
AS external-route tag value is invalid. Specify a value within the
range of 0 to 2147483647.
<Value>: Specified AS external route number
aggregate: invalid high end of range value at
<Value> not in range 0 to {32|128}
In the between specification, upper limit value of a mask range is
invalid. Specify a value within the range of 0 to 32/128.
<Value>: Upper limit value of the specified mask range
aggregate: invalid {inet|IPv6} mask bits value
at <Value> not in range 0 to {32|128}
At masklen/prefixlen, the mask length is invalid. Specify a value
within the range of 0 to 32/128.
<Masklen>: Specified mask length
aggregate: invalid low end of range value at
<Value> not in range 0 to {32|128}
In the between specification, lower limit value of a mask range is
invalid. Specify a value within the range of 0 to 32/128.
<Value>: Lower limit value of the specified mask range
aggregate: invalid number of communities
value at <Value> not in range 0 to 25
Specified community count is over the limit. Specify a value of up to
25.
<Value>: Specified number of communities
aggregate: invalid octet value at <Value> not
inrange0to255
Specified community count is over the limit. Specify a value of up to
25.
<Value>: Specified value
aggregate: invalid preference value at
<value> not in range 0 to 255
Preference value is invalid. Specify a value within the range of 0 to
255.
<Value>: Specified preference value
aggregate: invalid range end: <Value> With aspath_term {m, n} specified, m>n or n is 256 or more. Set the
starting value below the ending value. Or, set the ending value to 255
or less.
<Value>: Specified ending value (n)
aggregate: invalid range start: <Value> With aspath_term{m,n}, {m}, {m,} specified, m is 256 or more. Set to
255 or less.
<Value>: Specified starting value (m)
aggregate: invalid vpn number value at
<Value> not in range 1 to <Max_Value>
VPN number is invalid. Specify a value within the range of 1 to
<Max_Value>.
<Value>: Specified VPN number
<Max_Value>: Maximum VPN number
aggregate: iPv6 prefix cannot be linklocal in
configuration.
Linklocal address is specified in network address. Do not use the
linklocal address.
aggregate: iPv6 prefix cannot be multicast in
configuration.
Multicast address is specified in network address. Do not use the
multicast address.