Command Reference Guide
of the offline port causes the online partner port to undergo mode change as well. This results
in loss of use of the partner port because it is no longer online.
• Issuing the controlport rst -l command affects both ports of a port pair. Only use this
command when irreversible damage has been done to a port or port pair.
• When issuing the controlport cl2 or vcn commands, if the port is configured as peer
connection mode, an error is returned.
• If specified, <ctval> will depend on the <connmode> value:
• If <connmode> is disk, then <ctval> can only be loop
• If <connmode> is rcfc, then <ctval> can only be point
• If <connmode> is host, then <ctval> can be either loop or point
• if <connmode> is peer, then <ctval> can only be point.
94 Control Commands