Command Reference Guide

dismounted, SMIS-S Agent will force dismount if the option is selected. Otherwise,
instant recovery fails.
VSS_ENTERPRISE_VIRTUAL_ARRAY_OPTIONS
-no_copy_back
If this option is specified, a replica from the specified backup session is switched
with the source volume. Once used, the replica is not available for another instant
recovery session.
-copy_back
If this option is specified, copy back is performed. This is also the default behavior
when neither -no_copy_back nor -copy_back is specified.
—diskarray_wait Minutes
If this option is specified, there is a delay before the background processes can
run. The duration of the delay (in minutes) is determined by Minutes. This is
also the default behavior when neither -diskarray_wait nor
-no_diskarray_wait are specified, in which case there is a 60–minute delay.
-delete_replica
If this option is specified, the replica from which data was restored is deleted
from the disk array after restore.
-no_diskarray_wait
If this option is specified, the background processes, such as integrity check, will
not stop during the copy creation. This may cause a slowdown of the copy
process.
-no_retain_source
Overwrites the source volume during the switch or copy process.
Caution: If this option is specified and the instant recovery session fails, the
original data on the source volume will be lost.
VSS_DISK_ARRAY_XP_OPTIONS
-copy_back
Performs resynchronization of the disk pair, copying data from the target volume
(backup disk) to the source volume. This option must be specified if the data was
backed up with VSS provider in the resync mode.
-no_retain_source
Overwrites the source volume. This option must be specified if the data was
backed up with VSS provider in the resync mode.
Caution: If this option is specified and the instant recovery session fails, the
original data on the source volume will be lost.
Command line interface reference 79