HP 3PAR OS 3.1.3 Command Line Interface Reference

servicenode
DESCRIPTION
The servicenode command informs the system that a certain component is to be replaced, and
causes the system to indicate the physical location of that component.
SYNTAX
servicenode <subcommand> [options] <nodeid>
AUTHORITY
• Super, Service
• Any role granted the node_service right.
NOTE: You need access to all domains in order to run this command.
SUBCOMMANDS
start
Specifies the start of service on a node.
status
Displays the state of any active servicenode operations.
end
Specifies the end of service on a node.
OPTIONS
-ps <psid>
Specifies which power supply will be placed into service.
-pci <slot>
Specifies which PCI card will be placed into service.
-fan <fanid>
Specifies which node fan will be placed into service.
-drive
Specifies that the node's internal drive will be placed into service.
-bat
Specifies that the node's battery backup unit will be placed into service.
SPECIFIERS
<nodeid>
Indicates which node the servicenode operation will act on. Accepted values are 0 through 7.
RESTRICTIONS
Access to all domains is required to run this command.
servicenode 257