HP 3PAR OS 3.1.3 Command Line Interface Reference

setsys
DESCRIPTION
The setsys command sets the properties of the system, and includes options to annotate a system
with descriptor information such as physical location, owner, contact information, and so on. The
command also enables you to set system-wide parameters such as the raw space alert.
SYNTAX
setsys [options]
setsys <parameter>
AUTHORITY
• Super, Service
• Any role granted the sys_set right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
The following option is designed for changing the name of the system:
-name <systemname>
Specifies the new name of the system up to 31 characters in length.
The following options allow the annotation of the system with descriptor information:
-loc <location>
Specifies the location of the system.
-owner <owner>
Specifies the owner of the system.
-contact <contact>
Specifies the contact information for the system.
-comment <comment>
Specifies any additional information for the system.
SPECIFIERS
The following parameters can be configured on the system and are issued for the <parameter>
specifier:
EventLogSize
Sets the size of the event log; default value is 3MB. When the event log is full, older events are
deleted in order to retain this setting. Parameter range is 512KB to 4MB.
RawSpaceAlertFC <value>
Sets the user configurable space alert threshold (10 to 100000 GB) for Fibre Channel type drives.
When the total space on the available chunklets (both clean and unclean) for the specified drive
type falls below the specified value, the alert is posted. A value of 0 will disable the alert.
RawSpaceAlertNL <value>
Performs the same function as RawSpaceAlertFC, but should be used for nearline type drives.
RawSpaceAlertSSD <value>
322 Set Commands