HP 3PAR OS 3.1.3 Command Line Interface Reference

• VCN. VLUN State Change Notification support setting. Valid values are n/a, enabled or
disabled. When enabled and in public loop or fabric topology, a Registered State Change
Notification (RSCN) message is issued to the fabric controller whenever a VLUN is created
or removed.
• IntCoal. Indicates whether the interrupt coalesce setting is Enabled or Disabled.
The following example displays information about all remote-copy ports:
cli% showport –rc
N:S:P State HwAddr Rate Type
5:3:2 ready 25320002AC000006 2Gbps rcip
4:1:1 ready 24110002AC000006 2Gbps rcip
0:5:1 ready 0002B39B2013 100Mbps rcip
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• State. State of the port.
config_wait. Configuration waiting.◦
◦ alpa_wait. ALPA waiting.
◦ login_wait. Login waiting.
◦ ready. Link is ready.
◦ loss_sync. Link loss sync.
◦ error. Currently in an error state.
◦ non_participate. Link not participating.
◦ taking_coredump.Coredump in progress.
◦ offline. Link is offline.
◦ fw_dead. Firmware dead.
◦ link_idle_for_reset. Link is idle for reset.
◦ dhcp_in_progress. DHCP is in progress.
◦ pending_reset. Link reset is pending.
◦ unknown. Link state is unknown.
• HwAddr. A unique identifier of the port hardware used for remote-copy connection. For an
RCIP port, it is the MAC address of the port.
• Rate. Data transfer rate (bitrate) for the remote-copy interface.
• Type. Indicates the port connection type.
• rcip. Port is used for remote copy over IP (RCIP).
The following example displays the detailed state of the port:
cli% showport –state
N:S:P --State-- -Detailed_State-
0:0:1 ready loss_sync
0:0:2 ready loss_sync
436 Show Commands