HP Data Protector Operations Guide

7. Right-click SNMP Service and select Properties.
a. Select the Traps tab. Enter public in the Community name text box and the hostname
of the Management Server in the Trap Destinations text box.
b. Select the Security tab. Under Accepted community names, select the community
public, click Edit and set Community rights to READ CREATE.
c. Confirm your settings.
8. Run
omnisnmp.
Note: The community name is case sensitive.
To finish the setup, there are a few additional configuration steps.
Running omnisnmp
When following step 1, the following popup message may appear:
Action: Perform steps 2 to 7 and rerun step 1 when this message appears.
After successful configuration, you should see the following popup message:
Setting OVdests trap destination
Action: To enable SNMP trap forwarding on Data Protector, edit the OVdests file to add the
remote trap destination host IP address:
Add the Server hostname as trap destination to the
OVdests file in the Data Protector root or the
Omniback/Program Files/Config/server/SNMP directory.
C:\Program Files\OmniBack\Config\Server\SNMP
10/23/2006 04:35 PM 22 OVdests
10/23/2006 04:35 PM 17 OVfilter
Example:
trap-dest: 10.50.3.38
47 | Page