Installing SCO UnixWare on an HP Netserver

NetServer Controller Package Name
E 30,40,45 AHA2910 adsl
LC Plus AIC7770 adsa
LC II,3 AIC7880 adsl
LD Pro AIC7880 adsl
LH AIC7855 adsl
LH Plus, LH Pro AIC7880 adsl
LH II,3 AIC7880 adsl
LS AIC7870 adsl
LX, LXe, LXr Pro AIC7880 adsl
LPr Symbios895 c8xx
LH3,LH4, Symbios895 c8xx
NetRaid 3Si mega
LC 2000 Symbios895 slha & mega
LH 3000 Symbios896 slha & mega
LH 6000 Symbios896 slha & mega
LT 6000r Symbios896 slha & mega
NOTE: HP currently does not support ultra SCSI mode on the AIC7880
controllers when they are connected to the HP Storage System 6. Ultra SCSI
mode is supported for disks installed in the HP NetServer cabinet.
Troubleshooting
SCO UnixWare is very specific about the hardware configuration it expects when
installing. The following limitations apply:
The root hard disk and the install device should both be on the primary SCSI channel.
The root hard disk must be SCSI ID 0. The first SCSI tape drive must be SCSI ID 2.
The first SCSI CD-ROM drive must be SCSI ID 5.
The correct SCSI ID is especially important if you are installing from the tape or CD-
ROM drive. If you have a complicated hardware configuration, install SCO
UnixWare using only the minimum system required to install. All additional
hardware can be added afterwards.