OSI/FTAM Programming Reference Manual

FTM Procedures
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
4-90
FTM_FILE_OPEN_CNF_
FTM_FILE_OPEN_CNF_
This procedure allows you to retrieve the remote responder’s response to the
application’s request to select and open a file or optionally create and open a file.
error return value
INT
indicates the outcome of the call. For a list of defined values, see Appendix B,
NonStop FTAM Initiator Error Messages.
cepi input
INT:value
is the connection endpoint identifier (CEPI) used to identify the specific
association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_
procedure for this association. For additional information on using the cepi
parameter, see the OSI/FTAM Programming Guide.
cepi is a required parameter.
state-result output
INT(32) .EXT:ref:1
indicates if the responder established the file-open regime as requested. Valid
values are as follows:
ZFTM-VAL-STATE-SUCCESS
ZFTM-VAL-STATE-FAILURE
state-result is an optional parameter.
action-result output
INT(32) .EXT:ref:1
summarizes information available in the diagnostic parameter. The action-
result value is never less severe than the most severe diagnostic value. Valid
values are the following:
ZFTM-VAL-ACTION-SUCCESS
ZFTM-VAL-ACTION-FAILURE
error := FTM_FILE_OPEN_CNF_ ( cepi ! I
, [ state-result ] ! O
, [ action-result ] ! O
, [ filename ] ! O
, [ initial-attrib ] ! O
, [ contents-type ] ! O
, [ diagnostic ] ) ; ! O