OSI/FTAM Programming Reference Manual

FTM Procedures

HP NonStop OSI/FTAM Programming Reference Manual—528611-001

4-149

FTM_U_ABORT_IND_

This procedure allows you to retrieve information on the user abort generated by the

remote responder.

error return value

INT

indicates the outcome of the call. For a list of defined values, see Appendix B,

NonStop FTAM Initiator Error Messages.

cepi input

INT:value

is the connection endpoint identifier (CEPI) used to identify the specific

association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_

procedure for this association. For additional information on using the cepi

parameter, see the OSI/FTAM Programming Guide.

cepi is a required parameter.

action-result output

INT(32) .EXT:ref:1

summarizes information available in the diagnostic parameter. The action-

result value is never less severe than the most severe diagnostic value.

Valid values are the following:

ZFTM-VAL-ACTION-SUCCESS

ZFTM-VAL-ACTION-FAILURE

A value of ZFTM-VAL-ACTION-FAILURE indicates that the operation was not

successful, and diagnostic is likely to contain one or more diagnostic

messages.

action-result is an optional parameter.

diagnostic output

INT .EXT:ref:(ZFTM-DDL-DIAGNOSTIC)

provides information that qualifies the success or explains the failure of a

requested action. For a complete list of possible diagnostic values, see

Appendix C, ISO FTAM Diagnostic Messages.

diagnostic is an optional parameter.

error := FTM_U_ABORT_IND_ ( cepi ! I

, [ action-result ] ! O

, [ diagnostic ] ) ; ! O