OSI/MHS P7 Application Programmatic Interface (P7 API) Manual

Return Codes
OSI/MHS P7 Application Programmatic Interface (P7 API) Manual—424825-001
B-8
Return Code Values
211 ZMHS_VAL_DT_INVAL_SEQ_NUM
Cause. An internal P7 API/LO protocol error occurred. Either the sequence number of
the block of data being sent by the P7 API does not match that expected by the LO
group, or the sequence number of the block of data being sent by the LO group does not
match that expected by the P7 API. The problem could be an internal software error in
OSI/MHS or corrupted data buffers used by the P7 API or other parts of the OSI/MHS
subsystem. The subcode contains the sequence number in question.
Effect. The procedure is not performed.
Recovery. Call LOS_DT_SEND_ with the data type set to ZMHS-VAL-DT-MS-
UNBIND-ARG, then open a new application association and try the operation again. If
this recovery procedure does not solve the problem, contact your Compaq
representative.