HP-UX IPSec A.01.07.02 Release Notes

HP-UX IPSec Release Notes
Pre-Installation Migration Instructions
Chapter 18
By default, HP-UX IPSec log files are located in the /var/adm/ipsec directory. The log file
name format is audit
date_information .log.
Migrating from Versions Prior to A.01.03
If you are updating to HP-UX IPSec version A.01.07.02 from a version released prior to
A.01.03 (such as version A.01.01 or A.01.02) and want to re-use your configuration files, you
must use the following procedure to first update to HP-UX IPSec version A.01.05, then update
to version A.01.07.02:
1. Verify that HP-UX IPSec is already configured with a valid IPSec password and
configuration file. To do this, use the ipsec_admin -start command to start HP-UX
IPSec. After you have verified HP-UX IPSec, stop it using the ipsec_admin -stop
command.
2. Check the automatic boot-up setting in the ipsec_mgr GUI under the Options menu. If it
is enabled, deselect Boot-up Options.
3. Install HP-UX IPSec version A.01.05.
If you need a copy of the HP-UX IPSec A.01.05 product, contact your HP representative.
4. Manually start HP-UX IPSec using the ipsec_admin -start command. This creates data
needed to migrate to HP-UX IPSec version A.01.07.02.
5. Stop HP-UX IPSec using the ipsec_admin -stop command.
6. Install HP-UX IPSec version A.01.07.02.
Not Re-using Configuration Files
If you do not want to re-use existing configuration files, you can update directly to HP-UX
version A.01.07.02 Use the swremove utility to remove the existing version of HP-UX IPSec,
then install HP-UX IPSec version A.01.07.02.
If you had a certificate issued for the system, contact your PKI administrator and have the
original certificate for the system revoked.